Hasselblad 848 Bedienungsanleitung PDF herunterladen (Seite 22)

Troubleshooting

Below are a few common problems and how to solve them.

Problem: e Feeder is not recognized by the scanner or FlexColor

soware.

Solution: e electronic connection between the scanner and feeder

is probably not secure enough. Gently, but rmly, press the

Feeder down against the scanner. When the connection is

good and the scanner is turned on, the diodes on the front of

the Feeder will light. See also “Mounting the Batch Feeder”

on page 8.

Problem: e original holders are not fully drawn in or out of the

scanner.

Solution: e Feeder is probably not aligned correctly for your indi-

vidual scanner. Check and correct the alignment as described

in “Aligning the Feeder” on page 23.

Problem: It is dicult to insert an original holder into one specic

slot of the Batch Feeder

Solution: ere may be an obstruction in the aected slot. Look all the

way inside the slot. Here you should see some strips of mag-

netic tape, which can sometimes come loose. If the tape has

come loose, simply press it down using the alignment tool

that came with your Feeder.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Keine Kommentare

Hasselblad 848 Bedienungsanleitung Seite 22